Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Huntington
If your chimney is pulling away from the roofline, leaking at the flashing, or venting a wood stove through a flue nobody has looked inside for years, we handle the repair here in Huntington. Fort Wayne Chimney Sweep is a chimney-only company: we inspect, we clean, and we fix what we find with the same crew, so you aren’t handed off to a second contractor once the camera goes down the flue. Our technicians have up to experience, and we bring real diagnostic evidence to every Huntington job. Call (866) 589-6152 to book a repair estimate.
Why Huntington Homeowners Call Fort Wayne Chimney Sweep for Chimney Repair
Huntington has a lot of old chimneys, and old chimneys are where bad advice happens. A contractor who only sweeps has an incentive to find problems he can’t fix; a generalist who mostly does roofs and gutters treats a flue as an afterthought. We do nothing but chimneys, flues, and venting, which means the person who cleans yours is the person who repairs it and the person who signs off on it. That single point of accountability matters in a town where so many stacks are original.
Homeowners around the courthouse square and the older blocks of Huntington call us because they’ve been told they need a full reline before anyone showed them why. We don’t work that way. Nothing gets recommended until a camera has run the full flue and smoke chamber and you’ve seen the footage yourself. If a repair can wait, we say so. We work with six professional-grade product lines – DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield – so the recommendation follows the chimney, not whichever supplier we happen to favor. Serving Huntington and the surrounding towns is a regular part of our week, and the drive out from Fort Wayne is short enough that a booked repair gets handled without shuffling you around.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Chimney Liner Installation in Huntington
Chimney liner installation in Huntington is usually the answer when an old unlined brick flue is asked to vent a wood stove or insert it was never sized for. The flue is too large for the appliance, the gases cool before they leave the top, and creosote collects faster than the homeowner expects. A correctly sized insulated stainless liner – DuraFlex or Olympia Chimney, depending on the stack – solves that by matching the flue to the appliance and keeping the exhaust hot. Where the existing clay tile is sound but cracked or pitted, HeatShield or Gelco cast-in-place resurfacing can restore the flue without a full tear-out, and that’s often the less expensive column. Typical liner installation in Huntington runs $2,200-$4,500 depending on height, flue condition, and whether insulation or a cap is included. The written estimate sets the final price.
Sizing the liner to the appliance
The liner has to match the appliance’s venting requirement, not the hole in the masonry. An oversized coal-era flue relined to the wrong diameter just rebuilds the original draft problem. We size it from the appliance specs and confirm it on the camera before anything is ordered.
When resurfacing is enough
If the tile is intact and the damage is confined to joints and mortar, cast-in-place resurfacing can add years to the flue at a fraction of relining cost. When the tile is cracked through or missing sections, resurfacing won’t hold, and we’ll show you the footage that proves it.
Chimney Flashing Repair in Huntington
Chimney flashing repair in Huntington is the fix for the leak that shows up as a stain on the ceiling after a hard rain, not after a fire. The flashing is the metal where the chimney meets the roof, and on older Huntington homes it’s frequently original galvanized that has rusted through or step flashing that was never properly counter-flashed into the brick. Water gets behind it, works into the masonry, and shows up inside. We pull the old flashing, cut a proper reglet or use a surface-mounted apron depending on the stack, seal it correctly, and check that the crown above it is shedding water too. Typical flashing repair in Huntington runs $350-$850, with a full rebuild of the flashing system at the higher end. You get an exact figure from the written estimate.
Flashing versus crown leaks
Not every ceiling stain comes from the flashing. A cracked crown lets water straight down through the flue. We check both on the same visit so you’re not paying twice to fix the wrong joint.
Why the counter-flashing matters
Flashing caulked to the face of the brick will fail again. The metal has to be set into the masonry so water runs over it, not under it, and that’s the part cheap repairs skip.
Trusted Brands We Service in Huntington
We’re trained and equipped on DuraFlex and Olympia Chimney stainless liner systems, HeatShield and Gelco cast-in-place resurfacing, and Famco and Copperfield components, and we service existing installations in all of them. We don’t claim to stock parts locally – what we bring is the knowledge of how each system performs in a Huntington flue and the ability to order the right one without a week of guesswork. That means fewer return visits and a repair that’s matched to the chimney instead of the closest thing on a shelf. See our full chimney repair services for what we handle.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Huntington Homes
- Wood stoves set into unlined fireplaces. Homeowners drop a stove into the original firebox and vent it straight up a bare brick flue. Heat and creosote then hit deteriorating mortar joints directly, and there’s nothing between the exhaust and the house but old masonry.
- Third-degree creosote in oversized flues. Coal-era stacks were built wide, and once they were reconnected to wood stoves the gases cooled and glazed the flue with hard creosote a standard brush won’t touch. That’s a cleaning-and-inspection job before it’s a repair.
- Spalling brick and cracked mortar on the exterior stack. Huntington’s freeze-thaw cycling works moisture into the brick, and the face pops off. Once the brick spalls, water gets deeper in and the draft suffers.
- Failed flashing and cracked crowns. Original galvanized flashing rusts through, and old crowns crack at the flue. Both send water into the chimney, and both are cheap to fix compared to the masonry damage they cause if ignored.
Pricing for Chimney Repair in Huntington, IN
We quote repair work per job by written estimate, and the estimate is free. Typical mortar repointing on a Huntington stack runs $500-$1,200 depending on how much of the joint needs cutting out. Spalling brick repair – replacing the popped faces or the damaged courses – generally lands $600-$1,500. Chimney waterproofing runs $300-$700 for a breathable treatment on the exterior stack. Chimney rebuilding, where the top courses or the whole stack above the roofline have to come down and go back up, starts around $3,000 and climbs with height and access. What moves the number: chimney height, roof pitch, how much of the work can be reached safely, and whether the damage is surface-level or structural. Repointing that’s skipped doesn’t get cheaper – it turns into a rebuild. The written estimate is the final word on price, and you’re not committed to anything until you’ve reviewed it.
We Also Serve Cities Near Huntington
Huntington sits close enough to our Fort Wayne base that repair work here is routine, and we serve the towns around it the same way – Ossian, Columbia City, Bluffton, and Fort Wayne. If you’re just outside Huntington and not sure whether we cover your address, call and ask. The chimney problems don’t change much from one of these towns to the next, and neither does how we handle them.
Serving Huntington, IN – Our Local Coverage Area
We serve Huntington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Repair in Huntington
It can be cleaned, but we wouldn’t call an unlined brick flue safe to use as-is once we’ve seen inside it. Bare brick and mortar joints were never meant to carry wood-stove exhaust and creosote directly, and once the mortar starts to fail there’s nothing containing the heat. The honest path is a Level 2 camera inspection to see the full flue, then a decision: a correctly sized liner if you want to keep using the fireplace or stove, or a documented recommendation to stop using it until it’s relined. Call (866) 589-6152 for an exact quote – estimates are free.
Because the flue is oversized for the appliance. Many Huntington chimneys were built wide for coal furnaces and later reconnected to wood stoves, and the larger, cooler flue lets exhaust gases condense before they clear the top – so creosote builds faster than it would in a modern stack sized to the stove. That pattern is concentrated in the older blocks near the downtown courthouse square, where the coal-to-wood conversions happened. A camera inspection tells you whether the flue is simply too big or whether there’s glazed creosote that needs professional removal before anything else. Call (866) 589-6152 for an exact quote – estimates are free.
A basic cleaning is enough only when the flue is already sound and you’re not changing anything. If you’ve added a wood stove or insert, moved into a Huntington home with an unknown chimney history, had a chimney fire, or are being told you need a liner or a rebuild, a Level 2 camera inspection is the standard – it sees the full flue and smoke chamber, which a brush never will. We run it before recommending any repair. Call (866) 589-6152 for an exact quote – estimates are free.
That’s efflorescence and spalling, and it means moisture is inside the brick. Huntington’s freeze-thaw cycling drives water into the masonry, and when it freezes it pushes the brick face off. It’s a repointing-and-waterproofing problem, not a cleaning problem, and it gets worse every winter it’s left. We check the crown and flashing on the same visit because that’s usually where the water is getting in. Call (866) 589-6152 for an exact quote – estimates are free.
You should see the evidence before you agree to anything. On every Huntington job we run a camera down the flue and show you the footage – the cracked tile, the failed mortar, the glazed creosote – and we tell you plainly when a repair can safely wait. If someone quotes a liner or a rebuild without showing you what’s wrong inside, that’s the upsell, and it’s common in older-chimney work here. Call (866) 589-6152 for an exact quote – estimates are free.
For chimney repair in Huntington that’s backed by camera footage you can see for yourself, call Fort Wayne Chimney Sweep at (866) 589-6152. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, and the price is set per job by the written estimate.
Written by the team at Fort Wayne Chimney Sweep.